I have an giga and it’s a bit finicky, I am hoping to troubleshoot. A Bambu it is not. I am a bit disappointed, because for bigger prints the printer is much less reliable so far than hoped. I had desired to be doing much more furniture design prototyping and projects than troubleshooting.
My primary issues are bed adhesion (even after good bed leveling), and layer adhesion. The first, leads to a quick failed print and sometimes a more catastrophic clog of the nozzle. The second, yields a bad quality print that has warping.
Right now I can sort of print PLA with a lot of brims (no brims, no joy) but my desired state is to print PETG, but the issues are proving too severe to get any success there.
I’ve done temperature towers, and am running hotter with a 0.6mm nozzle. I have textured pei print beds.
Anyone have any suggestions?
With no enclosure I would be pretty confident warping due to low ambient temp is what’s causing your print failures. With the top popped my chamber is around 40 °C / 104 °F and I haven’t experienced any PETG warping. My printer lives in my basement, which occupies a similar temperature range as your garage. On my old unenclosed i3 clone I would run into warping on bigger PETG prints.
If you’re feeling ambitious you could try throwing a (big) cardboard box over the whole thing and see if that helps. A few bed fans for good measure could be enough. I wouldn’t treat this as a permanent solution, but it could help you troubleshoot.