What could cause the strange part on the right? The whole surface should be the same, it’s a 90° wall, so nothing that should look like this. Can’t see anything strange in OrcaSlicer. BambuLab A1 Mini with Creality PLA+
What could cause the strange part on the right? The whole surface should be the same, it’s a 90° wall, so nothing that should look like this. Can’t see anything strange in OrcaSlicer. BambuLab A1 Mini with Creality PLA+
Is it that height and up or just a band?
Just a band. But not all the was around. It is at overhangs and a little bit after them. But not before overhangs.
If it’s only overhangs then you may want to look at increasing the time between layers or increasing the part fan speed on overhangs.
This way there’s time for the layer before to solidify enough before adding more heat and melted plastic above it.
May not be it but it does have a kind of “overheated” look to it.