Kind of describes the issues for many men don’t it.

There are far worse role models.

Dude, you are looking sharp today. Don’t ever think you can’t look good.

I often see an issue when trying to communicate your point here, (which I agree with and I also agree that that Patriarchy is a problem), there is no good way to name and call out those as you put it “radical anti-patriarchy combatants.”

Very few are willing to name or talk about “the Matriarchy” or “toxic Femininity.” So we either end up trying to use a long string of less impactful words, (like you did), or we just sweep those “radical anti-patriarchy combatants” under the too broad umbrella of Patriarchy and end up hidden from sight.

So the next time you need to call out one of those radical anti-patriarchy combatants, name them for what they are-- a toxic feminist and are adding to the problem of the Matriarchy. Just as you would call out any toxic male as being a problem part of the Patriarchy. Then sit back and watch them come unglued.

Because we desperately need equality for all and we need to support each other as best we can and when we can. To quote the famous Canadian philosopher, Red Green-- “Remember, we’re all in this together.”

It’s not like ANYONE driving in Chicago looks where they are going. Ever.

Pretty hard to keep your rear plate uncovered when driving in snow conditions. The air currents pack it in there like that as you drive. And it can only take a few mintues of driving to make it happen.

But the roof? Yeah get that cleaned off!

I am a veteran of that war. I shitposted for Vim. The scars that war left will never heal. The nice doctor here is trying to get me to use nano. Baby steps she says. But she say says soon I will be using Kwrite.

:q No wait! I think I meant :q! Crap, I wanted to save that. :wq

I would bet on retraction here. Dial that in and 90% of the stringing goes away.

Or just use a textured PEI plate at the proper bed temperature. There is very little need for special adjuncts to print PETG.

Machines are a means to an end. Not the end in and of itself. It just depends on what YOUR ends turn out to be.

There is nothing wrong with having your printer be the hobby. It’'s a valid part of of the printing hobby and the current state of 3D printing wouldn’t be it is right now. And Bambu has done nothing new that hobbyists weren’t already doing as a hobby to modify their machines. So I wouldn’t worry much about what a Bambu owner thinks.